New Radio Flashlight charger, china New Radio Flashlight charger manufacturer, New Radio Flashlight charger wholesale center

Main technical parametes: 1. Lighting A> With 1 LED, maximum brightness: 20000mcd, maximum light flux: 1.9lm; B>With 5 LEDs, maximum brightness: 70000mcd, maximum light flux: 6.9lm; C> After cranking for 1 minute, LED bulb can be turned on 80 minutes and 5 LEDs 40 minutes. 2. Mobile phone charging Output voltage: 5.7V/6.4V; Maximum output current: ?400mA; Maximum output power: 2.5W; Charging 3 minutes can provide 2-8 minutes of talk time. 3. Radio A> Radio frequency range: FM88~108MHz, FM76~92MHz B> 1 minute of cranking charge can make radio last for 7 minutes. 4. Application life: DC jack: 5000 times Earphone jack: 5000 times Switch: 10000 times LED bulbs: 100000 hours Plastic parts: 5 years Life span as a whole body: 5 years Use: 1. For lighting 1-1> Lift up the handle, hold the unit with one hand and crank it with another hand at the speed of 2.5-3 cycles per second for about 1 minute, then press the button for lighting. 2-2> Switch mode: press first for 1 LED on, second for 1 LED off, third for 5 LEDs on and forth for 5 LEDs off. 2. For charging a mobile phone 2-1> Open the DC cap, insert the cable head with "DC" mark into the DC hole and the other end to a suitable mobile phone or a intermediary plug; 2-2> Lift up the handle, hold the unit with one hand and crank it with another hand at the speed of 2.5-3 cycles per second, the mobile phone indicates charging effect on screen. 3. Radio: 3-1> Pull out the antenna, turn the power switch clockwise, a crack sound will heard to show power on.. 3-2>Press the RESET button to lock the frequency at the lowest end, then press the SCAN button to search a wanted channel automatically. If press the selection button several time but no channel can be locked, pls press the RESET button to start over. 3-3>Volume adjustment: turn clockwise to increase volume, otherwise to decrease volume. 3-4>Speaker switching: open the DC cap, insert earphone plug into the earphone hole and the speaker is cut for the earphone work. Withdraw the earphone plug, the speaker comes to work again. 3-5>Turn off radio: rotate the volume switch counterclockwise until a crank sound to be heard to shut off power