100A ESC for RC Car (DLC Series), china 100A ESC for RC Car (DLC Series) manufacturer, 100A ESC for RC Car (DLC Series) wholesale center

PULSO ESC (electronic speed controller ) is special design for RC Model Cars (DLC30A, DLC50A, DLC70A, DLC100A). It can be programmed by PC via USB Link easily.



Detailed Specifications For Car Model (DLC series):

I. Features:

1. Easy setting; Easy operation. It is designed for only Model car which can support 2-3cells Lipos and 5-8cells NICD/NIMH.

2. It can be connected to USB port of PC by USB cable; It is convenient to set all parameters of ESC.

3. Low-voltage cut-off:

By PC via USB cable, the LiIo/LiPo battery single cells cut-off voltage can be set during 2.0V-3.2V (Step: 0.1V);

By PC via USB cable, the Ni-MH/Ni-CD battery single cells cut-off voltage can be set during 0.4V-1.0V (Step: 0.1V).

4. Timing Mode: Timing Mode 1(0-7 degree) / Timing Mode 2(8-18 degree) / Timing Mode 3(19-24 degree) / Timing Mode 4(25-30 degree);

By PC via USB cable, timing mode can be set from 1-30 degree (Step: 1 degree)

5. Three kinds of Throttle Curves: Logarithmical/Linear/Exponential.

By PC via USB cable, It can be adjusted and with different acceleration ways.

6. Three kinds of throttle acceleration control: Soft \ medium \ hard. With throttle curve patterns, throttle curve can be set perfectly.

7. ABS Brake can be set by PC via USB cable.

8. Reverse function. Delaying time can be adjusted by PC via USB cable.

9. Limit power of Forward/reverse can be set by PC via USB cable.

10. With current limit function, after setting the peak current of ESC, no need to worry overloaded.

11. With the function of accelerator automatically detection or a fixed value can be set manually by PC via USB cable.

12. Automatic power cut-off. (When the radio signal loses for more than 3 seconds, the power will automatically be cut off. )

13. BEC (5V/2A) provides power to receiver and servos.

14. Over-heat protection. The power will be cut-off as it is heated up to 110.



II. Factory Default Setting:

1. Forward/brake/reverse mode

2. Timing mode 1 (0-7 degree)

3. Cut-off voltage mode 1 (Intellectual cut-off for Ni-MH/Ni-CD battery)



III. Operation with PC via USB cable (See users manual in PULSO Software Tool).