100A ESC for RC Helicopter (HDLH100A HDLH200A), china 100A ESC for RC Helicopter (HDLH100A HDLH200A) manufacturer, 100A ESC for RC Helicopter (HDLH100A HDLH200A) wholesale center

PULSO ESC (electronic speed controller) Master series (All models can be programmed by PC via USB LINK easily)

Model    Current BEC   LIPO      NIMH/NICD  Application

DLH11A   11 amp  2 amp 2-3 CELL  6-10 CELL  Helicopter

DLH22A   22 amp  2 amp 2-3 CELL  6-16 CELL  Helicopter

DLH33A   33 amp  2 amp 2-3 CELL  6-10 CELL  Helicopter

DLH70A   70 amp  No    2-6 CELL  6-10 CELL  Helicopter

HDLH100A 100 amp No    3-10 CELL 10-30 CELL Helicopter

HDLH200A 200 amp No    3-10 CELL 10-30 CELL Helicopter



For Helicopter Model (DLH series) User's Guide:

I. Features:

1. Easy setting; Easy operation. Specially designed for Helicopter.

2. It can be connected to USB port of PC by USB cable; It is convenient to set all parameters of ESC.

3. Safe start-up system: The motor wont be started no matter which position the throttle stick is on when the battery is connected.

4. Automatic power cut-off: As the motor stops rotating or the radio signal loses for more than 3 seconds, the power will automatically be cut off.

5. Over-heat protection: The power will be cut-off as it is heated up to 110.

6. No BEC: The receiver needs another electric power supply. (A 5V/3A UBEC can apply the power. )

7. Throttle acceleration selection: Slow/Medium/Hard.

8. Three throttle curve in selection: Logarithmical/Linear/ Exponential.

9. Soft Start mode/Constant Speed Start mode.

Under Constant Fixed Speed mode, you can choose motors with different poles for ESC to control the rotation speed correctly.

10. Low-voltage cut-off:

By PC via USB cable, the LiIo/LiPo battery single cells cut-off voltage can be set during 2.0V-3.2V (Step: 0.1V);

By PC via USB cable, the Ni-MH/Ni-CD battery single cells cut-off voltage can be set during 0.4V-1.0V (Step: 0.1V).

11. Timing mode: Timing mode: Timing mode 1: 0-7 degree/ Timing mode 2: 8-18 degree / Timing mode 3: 19-24 degree/ Timing mode 4: 25-30 degree.

By PC via USB cable, timing mode can be set from 1-30 (Step: 1 )



II. Factory Default Setting:

1. Soft Start mode;

2. Timing mode 1 (0-7 degree);

3. Cut-off voltage mode 1. (Intellectual cut-off for Ni-MH/Ni-CD battery);



III. Operation with PC via USB cable (See users manual in PULSO Software Tool).